Change a Propane Tank
Forklifts powered by propane are common inside warehouse settings. These forklifts have a propane mount located at the rear of the operator. These tanks have to be replaced every so often since they have limited lifespans. Forklift operators must always use care when handling propane tanks. Compressed gases are dangerous, particularly since the gas is flammable. Use caution when replacing and removing propane tank to prevent injury.
1 To change a propane tank, first stop the forklift and leave the engine running, and turn the valve on the tank off. Let the forklift run until the engine dies. This process burns off the gas inside the transfer hose that connects the tank and the engine. Before taking the next steps, put on the proper safety equipment, like for instance insulated gloves made of either leather or neoprene. It is really vital for you to protect your skin from touching the compressed gas, that is extremely cold.
2 The tank hose needs to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, tighten the nut to reattach the holding straps and to reconnect the hose at the valve of the tank.
3 Leaks could be inspected just by applying soapy water to the valve and opening it slightly. If there is a leak, it will cause bubbles to froth from around the valve. If this happens, check the connection hose at the nut and the valve area. The connecting nut must be re-tightened if you detect any leaks in the area of the valve, and after that do the leak checking procedure again. Persistent leaks mean that both the nut and connecting hose should be replaced. Then again, if replacing the hose and nut still does not stop the leak, the tank will have to be replaced.
4 Finally, open the valve all the way to allow the gas to fill the connecting hose. Afterward you can start the lift truck and resume working.